UC500-D1-3K-V7 PEPPERL+FUCHS - Part number: 212371

Datasheet excerpt: Technical data of  UC500-D1-3K-V7 Product Description Single head system General specifications Sensing range60 ... 550 mm Dead band0 ... 60 mm Standard target plate100 mm x 100 mm Transducer frequency380 kHz Response delay> 10 s, relay< 1 s, LEDs Indicators/operating means LED redLED 1: overfill indicationLED 4: underfill indication LED green/yellowLED 2: overfill warning and normal operation LED 3: normal operation and underfill warning DIP switchsetting of the switch points/operating modes Electrical specifications Operating voltage10 ... 253 V DC 20 ... 253 V AC , 47 ... 63 Hz No-load supply current< 30 mA with UB = 30 V DC< 110 mA at UB = 10 V DC< 25 mA at UB = 220 V AC Output Output type3 relay outputs, normally open/closed, selectable Range hysteresis20 mm Contact loading253 V AC/150V DC, 3 A (ohm. load) Life spanelectrical: 105 switching cycles with ohmic load(3 A/253 V AC or 3 A/30 V DC)minimum contact load: 100 µA/100 mV DCmechanical: 20 x 106 switching cycles Temperature influence< 4 % Fusing≤ 3 A Slow-blow fuse per output in accordance with IEC 60127-2 Sheet 5 required. Recommendation: after a short circuit, check that the device is functioning correctly. Compliance with standards and directives Standard conformity StandardsEN 60947-5-2:2007+A1:2012 IEC 60947-5-2:2007 + A1:2012 Approvals and certificates EAC conformityTR CU 004/2011 TR CU 020/2011 TR CU 037/2016 CCC approvalself-declaration Ambient conditions Ambient temperature-20 ... 60 °C (-4 ... 140 °F) Storage temperature-40 ... 85 °C (-40 ... 185 °F) Mechanical specifications Degree of protectionIP65 ConnectionFemale connector, V7 (7-pin), 90° Wire cross section: ≤1.5 mm2 cable diameter ∅7 ... 9 mm Material Housingcover: PC housing: PBTthreaded flange: stainless steel installation connector/cable socket: PETP Transducerepoxy resin/hollow glass sphere mixture; polyurethane foam Mass700 g NoteIn case of loss or damage, the cable socket must be replaced by an identical cable socket (type V7-W) from Pepperl+Fuchs! Classifications SystemClasscode ECLASS 11.027272803 ECLASS 10.0.127272803 ECLASS 9.027272803 ECLASS 8.027272803 ECLASS 5.127272803 ETIM 8.0EC001849 ETIM 7.0EC001849 ETIM 6.0EC001849 ETIM 5.0EC001849 UNSPSC 12.141111960 Datasheet excerpt: Technical data of  UC500-D1-3K-V7 Product Description Single head system General specifications Sensing range60 ... 550 mm Dead band0 ... 60 mm Standard target plate100 mm x 100 mm Transducer frequency380 kHz Response delay> 10 s, relay< 1 s, LEDs Indicators/operating means LED redLED 1: overfill indicationLED 4: underfill indication LED green/yellowLED 2: overfill warning and normal operation LED 3: normal operation and underfill warning DIP switchsetting of the switch points/operating modes Electrical specifications Operating voltage10 ... 253 V DC 20 ... 253 V AC , 47 ... 63 Hz No-load supply current< 30 mA with UB = 30 V DC< 110 mA at UB = 10 V DC< 25 mA at UB = 220 V AC Output Output type3 relay outputs, normally open/closed, selectable Range hysteresis20 mm Contact loading253 V AC/150V DC, 3 A (ohm. load) Life spanelectrical: 105 switching cycles with ohmic load(3 A/253 V AC or 3 A/30 V DC)minimum contact load: 100 µA/100 mV DCmechanical: 20 x 106 switching cycles Temperature influence< 4 % Fusing≤ 3 A Slow-blow fuse per output in accordance with IEC 60127-2 Sheet 5 required. Recommendation: after a short circuit, check that the device is functioning correctly. Compliance with standards and directives Standard conformity StandardsEN 60947-5-2:2007+A1:2012 IEC 60947-5-2:2007 + A1:2012 Approvals and certificates EAC conformityTR CU 004/2011 TR CU 020/2011 TR CU 037/2016 CCC approvalself-declaration Ambient conditions Ambient temperature-20 ... 60 °C (-4 ... 140 °F) Storage temperature-40 ... 85 °C (-40 ... 185 °F) Mechanical specifications Degree of protectionIP65 ConnectionFemale connector, V7 (7-pin), 90° Wire cross section: ≤1.5 mm2 cable diameter ∅7 ... 9 mm Material Housingcover: PC housing: PBTthreaded flange: stainless steel installation connector/cable socket: PETP Transducerepoxy resin/hollow glass sphere mixture; polyurethane foam Mass700 g NoteIn case of loss or damage, the cable socket must be replaced by an identical cable socket (type V7-W) from Pepperl+Fuchs! Classifications SystemClasscode ECLASS 11.027272803 ECLASS 10.0.127272803 ECLASS 9.027272803 ECLASS 8.027272803 ECLASS 5.127272803 ETIM 8.0EC001849 ETIM 7.0EC001849 ETIM 6.0EC001849 ETIM 5.0EC001849 UNSPSC 12.141111960